Bobrick paper towel dispenser,hand dryer and garbage bin combination

Bobrick 3in1 230V combination paper towel dispenser/hand dryer/waste bin 230V

The combined unit of paper towel dispenser, automatic handdryer and waste bin for wall recessed, consists of a completely welded stainless steel construction (CrNi 18/10).

- Recessed Paper Towel Dispenser, Automatic Hand Dryer, And Waste Bin (3-in-1 unit) shall be type-304 stainless steel with all-welded construction; exposed surfaces shall have satin finish.
- Doors shall be 1.2mm (18-gauge); have 14mm (9/16") 90° return edges; be secured to cabinet with concealed, full-length stainless steel piano-hinges; and equipped with a stainless steel cable door-swing limiter and two flush tumbler locks per door keyed like other Bobrick washroom accessories.
- Paper towel dispenser shall be capable of dispensing 600 multifold or 450 C-fold paper towels.
- Unit equipped with TowelMate consisting of a 90° return towel guide angle inside cabinet to prevent paper towels from falling forward out when door is opened for servicing and a Nylon Rod across the center of the towel tray to dispense paper towels one at a time.
- Waste bin shall be furnished with a removable, leak-proof, rigid molded plastic waste-container with a capacity of 13.7 liters (3.6 gal.).
- Directed air nozzles shall prevent dryer from blowing into waste bin. Hand dryer shall have a one-piece,18-8, type-304, 0.8mm (22-gauge) stainless steel cover
- Dryer mounting base shall be 1.5mm (20-gauge) plated steel with three 6mm (0.236") diameter mounting holes. Fan housings shall be fire-retardant molded black plastic.
- Dryer shall be equipped with dual air outlets that run through two vertical ducts and out the black plastic nozzles under the towel dispenser.
- Motor shall be 1/7 hp, universal type on resilient mounting with sealed ball bearing at drive-shaft end and self-lubricating sleeve bearing at nondrive end; equipped with automatic thermal-overload switch.
- Heating elements shall be located on outlet side of fan, shall heat air without hot spots, be inaccessible to vandals, and protected by an automatic thermal-overload switch.
- The dryer will be controlled by the activation sensor which is part of the electronic control. The electronic control will never allow the dryer motor to be hotter than 70°C.
- There are two modes of operation, dryer promotion and paper promotion.
- Dryer promotion mode, the dryer shall turn on when hands are held under air-outlet opening and across path of sensor.
- Paper promotion mode, there will be a three (3) second delay between seeing the hands and when the dryer turns on. Dryer shall turn off automatically when hands are removed.
- Sensor shall automatically shut dryer off approximately 1-1/2 minutes after dryer turns on if an inanimate object is placed in activation zone. After inanimate object is removed, electronic sensor shall automatically reset itself and dryer shall operate normally.
- The electronic control will have an LED that will flash green when the dryer is ready, be solid green when the dryer is running and be solid red when the dryer is not ready. 



Data:
- Steel case
- Automatic hand dryer 900 Watt
- A wall recess with 362 mm width x 1412 mm height provide.
- Minimum installation depth 100mm (see installation instructions PDF)