Surface mounted soap dispenser 0,5-1L for manuell refill or cartridges stainless steel

BOBRICK cartridge soap dispenser 0,5-1L of satin brushed stainless steel

The cover is lockable with a Bobrick System lock. To refill the dispenser, open the cover by lifting and pulling forward.

The soap level indicator shows how much product is remaining in the dispenser. The plastic container can be removed and re-installed for quick and easy refilling. The plastic container can be used for soap cartridges (up to 500 ml), as well as bulk refilling of up to 500 ml of soap. To install a soap cartridge in the dispenser, open the cartridge and place it upside down inside the plastic container. Alternatively, soap can be poured directly into the plastic container. The dispenser has been designed for quick and easy refilling process.

After opening the dispenser cover, remove the plastic container, gently lifting it upwards while pressing the locking latch. Mount the dispenser to the wall by using the enclosed screws and wall plugs. Make sure the wall surface is in good condition to ensure proper mating of the dispenser to the wall. Use silicone or glue pads if necessary.

Note: 1. The dispenser should be installed near or directly above the sink to allow wet hands to drip into the sink. 2. Allow sufficient space above dispenser to exchange cartridges easily. 3. Recommended installation height: 100 – 110 cm (measured from floor to the bottom of the dispenser). Foam Pumps are not available in U.S or Canada.

Model B-26607 from Bobrick Washroom Equipment, Dispenser made of 0.8 mm thick, (22 gauge) 1.4301, Type CrNi 18/10, AISI 304 stainless steel with a brushed, satin finish; plastic container for soap cartridges (up to 500 ml), as well as for bulk refill of soap (up to 500 ml); lockable with a Bobrick System lock; soap level indicator.

Clean regularly with warm water and/or stainless steel cleaner. Do not use acid (chloride) cleaners or scouring agents. The suction valve can be cleansed by pumping hot water through it. Do not dismantle the dispenser. Use only original spare parts.

Technical Data:
B-26607:
width: 96mm
height: 298mm
advance: 116mm
capacity: 0,5 Liter

B-26617:
with: 96mm
height: 336mm
advacne:116mm
capacity:1 Liter

Data sheet B-26607 0,5L (English)


Data sheet B-26617 1L (English)