Elan hand dryer with sensor housing of satin brushed stainless steel 230V B-715E
Bobrick B-715E Elan handdryer contemporary styling, satin-finish type 304 stainless steel cover. Automatic hand sensor.
| Hoeveelheid | Prijs per eenheid |
|---|---|
| Tot 1 |
€ 721,10
|
| Tot 2 |
€ 711,20
|
| Tot 3 |
€ 701,25
|
| Tot 4 |
€ 691,35
|
| Tot 5 |
€ 681,40
|
| Tot 7 |
€ 671,45
|
| Tot 9 |
€ 661,60
|
| Vanaf 10 |
€ 651,65
|
voor levering naar Nederland.
Beschikbaar, Levertijd 6-10 werkdagen
55 Goswell Road 1st Floor Clerkenwell
EC1V 7EN London
Ierland
euoffice@bobrick.com
Herbert Place 25
D02 AY86 Dublin
Ireland
Telephone: +44 (0) 1793 78 45 45
euoffice@bobrick.com
Bobrick B-715E Elan handdryer 230V stainless steel surface mounting with hand sensor
No-touch operation. Electronic sensor automatically turns dryer on when hands are held under air-outlet opening and across path of sensor. Remove hands from path of sensor and dryer stops. Dryer will not stop by itself before user is satisfied hands are dry. Dryer operates only when actually drying hands, which saves energy and operating costs. Electronic sensor will automatically shut dryer off two minutes after dryer turns on if an inanimate object is placed across sensor lens. After inanimate object is removed, electronic sensor automatically resets itself and dryer operates normally.
Dimensions:
width 295 mm
height 280 mm
depth 140 mm
- Surface-mounted hand dryer shall have a deep-drawn, 20-gauge (0.9mm) thick, stainless steel cover with satin finish.
- Mounting base and fan housing shall be fire-retardant molded plastic.
- Capacitor run, external rotor motor shall be 90 watts, sealed with ball bearings on ends of drive shaft, and be equipped with a thermal overload switch.
- Centrifugal fan shall have multiple metallic vanes.
- Heating element shall be located on inlet side of fan, shall heat without hot spots, be inaccessible to vandals, and protected by an automatic thermal-overload switch and thermal fuse.
- Electronic sensor shall automatically turn dryer on when hands are held under air-outlet opening and across path of sensor.
- Dryer shall turn off automatically when hands are removed.
- Sensor shall automatically shut dryer off approximately two minutes after dryer turns on if an inanimate object is placed across sensor lens.
- After inanimate object is removed, electronic sensor shall automatically reset itself and dryer shall operate normally.
- Dimensions: width 295 mm height 280 mm depth 140 mm
- Surface-mounted hand dryer shall have a deep-drawn, 20-gauge (0.9mm) thick, stainless steel cover with satin finish.
- Mounting base and fan housing shall be fire-retardant molded plastic.
- Capacitor run, external rotor motor shall be 90 watts, sealed with ball bearings on ends of drive shaft, and be equipped with a thermal overload switch.
- Centrifugal fan shall have multiple metallic vanes.
- Heating element shall be located on inlet side of fan, shall heat without hot spots, be inaccessible to vandals, and protected by an automatic thermal-overload switch and thermal fuse.
- 230V AC, 15 Amp, 1725 Watts, 60 Hz. 11-5/8” (295mm) x 11” (279mm) x 5-9/16” (141mm).
Ähnliche Artikel
