Schuim zeepdispenser Bobrick 0,5-1L gesatineerd voor manuell vulling of cartridges

Bobrick surface mounted foam soap dispenser satin brushed stainless steel 0,5L-1L

- Push activated with less than 22.2N.
- Materiaal: oestvrij staal zijdeglans 1.4301, Typ CrNi 18/10, AISI 304
- Housing is satin brushed
- operating lever; metal lock and key;
- soap level indicator
- interchangeable plastic containers with plastic pumps; variety of plastic containers available including containers with pumps for soap or foam.

The cover is lockable with a Bobrick System lock. To refill the dispenser, open the cover by lifting and pulling forward. The soap level indicator shows how much product is remaining in the dispenser. The plastic container can be removed and re-installed for quick and easy refilling. The plastic container can be used for foam soap cartridges (up to 1000 ml- 500ml), as well as bulk refilling of up to 1000 ml - 500 mlof foam soap. To install a soap cartridge in the dispenser, open the cartridge and place it upside down inside the plastic container. Alternatively, soap can be poured directly into the plastic container. The dispenser has been designed for quick and easy refilling process.

Note:
1. The dispenser should be installed near or directly above the sink to allow wet hands to drip into the sink.
2. Allow sufficient space above dispenser to exchange cartridges easily.
3. Recommended installation height: 100 – 110 cm (39" - 43") (measured from floor to the bottom of the dispenser).

Afmeting:
B-26627:
breedte: 96 mm
hoogte: 298 mm
projectie: 116 mm
inhoud: 0,5 Liter

B-26637:
breedte: 96 mm
hoogte: 336 mm
projectie: 116 mm
inhoud: 1,0 Liter

Data sheet B-26627 (Engels)


Data sheet B-26637 (Engels)


Care Instructions:
Clean regularly with warm water and/or stainless steel cleaner. Do not use acid (chloride) cleaners or scouring agents. The suction valve can be cleansed by pumping hot water through it. Do not dismantle the dispenser. Use only original spare parts